Body - Side Wall Seam Above Rear Lamps Cracked
Side wall seam above rear lamps cracked
Topic number LI64.30-N-048760
Version 1
Design group 64.30 Corner paneling
Date 02-01-2010
Validity Sprinter model designation 906.6##
Reason for change
Reason for block
Complaint:
1. The PVC sealing seam above the rear lamps is cracked.
2. Visible corrosion above the rear lamps at the transitions from the D-pillars to the rear side walls.
Cause:
The sealing seams were applied up to the area above the rear lamps and may have been penetrated by moisture.
2010 Mercedes Benz Truck Sprinter 2500 Crew (906.733) V6-3.0L DSL Turbo (642.898)
Page 63
Remedy:
Swift implementation of the necessary repair work prevents subsequent damage at a later date and can be performed without damage to the
paintwork. For this reason we would ask you to perform the necessary repair work as quickly
as possible!
Remove/install the rear lamps on both sides of the vehicle. Remove the sealing seams above the rear lamps from the joint to a height of approx. 20
cm. The adjacent paint surfaces should be masked with two layers of fabric tape to prevent
damage. Any existing corrosion features in the joints must be eliminated if necessary in accordance with MB guidelines. To do this, use primer
and filler materials from the paint partners approved in the warranty systems. Then remove the fabric tape and re-mask the exposed joints with
masking tape. Then prime the joints. Next, renew the masking tape again and apply a new sealing seam to the joints. Mold the new sealing seams and
extend then into the recesses for the rear lamps (see Fig. 1).
2010 Mercedes Benz Truck Sprinter 2500 Crew (906.733) V6-3.0L DSL Turbo (642.898)
Page 64
A corresponding WIS document is being prepared.
No comments:
Post a Comment