Skip to main content

Disclaimer2010 Cadillac Truck Escalade RWD V8-6.2L Technical Service Bulletin # 09-06-05-001 Date: 090130

Disclaimer2010 Cadillac Truck Escalade RWD V8-6.2L Technical Service Bulletin # 09-06-05-001 Date: 090130



Exhaust System - Sulfur Odor Explanation



INFORMATION



Bulletin No.: 09-06-05-001



Date: January 30, 2009



Subject:



Information on Sulfur Odor from Exhaust



Models:



2007-2010 GM Passenger Cars and Light Duty Trucks (Including Saturn)



2007-2010 HUMMER H2, H3



2007-2010 Saab 9-7X



with Gasoline-Powered Engines



Important:



This bulletin is not applicable to vehicles operating in Canada on Canadian sourced fuels. Canadian regulations limit the amount of sulfur in



gasoline to 80 PPM or less for all gasoline marketed in Canada with no exemptions.



Federal regulations limit the amount of sulfur in gasoline to 80 PPM (some states have lower limits; for example, California's limit is 30



PPM). The federal exception to this rule is an allowance for qualifying small refineries that permits up to 450 PPM until January 1, 2011. Sulfur



odor in exhaust from vehicles equipped with gasoline engines is caused by excess sulfur in the gasoline and it cannot be eliminated unless the



source of the sulfur is eliminated.



Important:



Replacement of catalytic converters for this condition is not an appropriate repair and will not correct the condition by itself.



Customers with vehicles that exhibit this condition should be advised of the information in this bulletin and be asked to switch the brand of gasoline



that they are using. In most cases, this will result in elimination of the sulfur odor by the time one tank full of gasoline is consumed if the gasoline



that was added is within the 80 PPM federal limit.



In order for the odor to be eliminated. two things must occur. First, the gasoline added to the vehicle must be at or below the federal 80 PPM limit.



Secondly, the vehicle must have run long enough to have consumed one tank of fuel containing a sulfur content of 80 PPM or less.



Although there is no way for a dealership to easily measure the amount of sulfur in gasoline, it's a good practice when asked for a recommended



brand of gasoline to recommend any of the Top Tier Detergent Gasoline Brands. Although Top Tier brands have not demonstrated that they contain



a lower sulfur content than other brands, their detergent additive package makes them a preferred choice when choosing a brand of gasoline for



your vehicle. A complete list of Top Tier Brands can be found in Corporate Bulletin Number 04-06-04-047H (in Canada, refer to Corporate



Bulletin Number 05-06-04-022E) or by accessing the website www.toptiergas.com.



2010 Cadillac Truck Escalade RWD V8-6.2L Page 227

Comments

Popular posts from this blog

P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.

P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.2010 Mercedes Benz E 63 AMG Sedan (212.077) V8­6.3L (156.985) Copyright ? 2013, ALLDATA 10.52SS Page 978 Possible cause: ­ A80 (Intelligent servo module for DIRECT SELECT) Affected functions: ­ Drive position selection ­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­ Test 1: Remedial action if control unit is faulty 'A80 (Intelligent servo module for DIRECT SELECT)' 1. Remedial action if control unit is faulty 'A80 (Intelligent servo module for DIRECT SELECT)' Operation number of operation texts and work units or standard texts and flat rates:27­0641Possible cause and remedy ­ Internal fault in control unit ­ Replace component A80 (Intelligent servo module for DIRECT SELECT). Additional measures ­ ­ Perform initial startup. Continue with button "F2" Initial startup The following procedure will guide you through all steps requ...

Dremel 4300-9/64 Versatile Corded Rotary Tool Kit with Flex Shaft and Hard Storage Case, High Power & Performance, Variable Speed- Engraver, Etcher, Sander, and Polisher, Ultimate Gift for the DIYER

  The Dremel 4300-9/64 is a versatile corded rotary tool kit designed for a wide range of applications, making it an excellent choice for DIY enthusiasts and professionals alike. Here’s an overview of its key features: ### Key Features 1. **Power and Performance**:    - **High Power Motor**: The 4300 features a powerful motor that provides efficient performance for various tasks, including engraving, etching, sanding, and polishing. 2. **Variable Speed**:    - **Adjustable RPM**: Offers a variable speed range (typically 5,000 to 35,000 RPM) for precise control, allowing you to match the speed to the material and task at hand. 3. **Flex Shaft Attachment**:    - **Enhanced Maneuverability**: The included flex shaft allows for more intricate work in tight spaces and provides a comfortable grip for detailed projects. 4. **Comprehensive Accessory Kit**:    - **Versatile Attachments**: Comes with a variety of attachments and accessories, including ...

D138, Diagnostic Trouble Codes ( DTC ): Manufacturer Code Charts

D138 The message from the auxiliary oil pump is not available on the CAN bus. Possible cause: M42 (Electric transmission oil pump) / N89 (Transmission oil additional pump control unit) Affected functions: Engine start ------------------------------------------------- Test 1: Check component M42 (Electric transmission oil pump). Check component M42 (Electric transmission oil pump). Operation number of operation texts and work units or standard texts and flat rates:27-0641Test prerequisite Battery voltage is OK. Test sequence Switch off ignition. Disconnect connector at component N89 (Transmission oil additional pump control unit). Use multimeter to check voltage directly at jacks of wiring harness for component N89 (Transmission oil additional pump control unit). Switch on ignition. Measure direct voltage with multimeter between 1 and 4Specified value - Voltage [8,5...16,4] V Question Is the measurement value OK?...