Thursday, December 2, 2021

2010 Mercedes Benz C 300 (204.054) V6-3.0L (272.947) Page 2133


- This CAN bus does not require external terminating resistors.



Legend and description for figure 1CAN-H: CAN bus HighCAN-L: CAN bus LowECU 1 ... n: Control unit 1 ... nLegend and description for figure



2U 1: Specification approx. 3,6 voltsU 2: Specification approx. 0 voltsU 3: Specification approx. 2,5 voltsU 4: Specification approx. 1,4 voltsU 5:



Specification approx. 5 voltsContinue with button F2



1.1.1.3.1. No further information available.



1.1.1.3.2. High-Speed CAN (125 kBit/s , 500 kBit/s)



General CAN fundamentals



High-Speed CAN (125 kBit/s , 500 kBit/s)



- 125 kBit/s : Interior CAN busSeries 221



- 125 kBit/s : Telematic CAN busSeries 221



- 500 kBit/s : For example:Drive train CAN bus



- 500 kBit/s : For example:Diagnostic CAN-Bus



- This CAN bus does not permit single-wire mode.



- This means that both CAN lines are always required for fault-free communication between the control units.



- This CAN bus requires external terminating resistors.



- The terminating resistors can be located in control units or voltage distributors depending on the CAN bus.



Legend and description for figure 1CAN-H: CAN bus HighCAN-L: CAN bus LowECU 1 ... n: Control unit 1 ... nCAN terminating resistor (



Example: 120ohms)Legend and description for figure 2U 1: Specification approx. 3,6 voltsU 2: Specification approx. 2,5 voltsU 3: Specification



approx. 1,4 voltsContinue with button F2

No comments:

Post a Comment