Saturday, December 25, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 769

2010 Cadillac Truck SRX FWD V6-3.0L Page 769



Rear Axle Schematics (See: Transmission and Drivetrain/Differential Assembly/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Rear Drive Axle Description and Operation (See: Transmission and Drivetrain/Differential Assembly/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



1. Engine running, observe the scan tool Rear Drive Clutch Status parameter. The scan tool should display TEMPORARILY LIMITED when



stationary.



2. Verify that the following DTC's are not set along with DTC C039F:



* C0402



* C0403



* C0406



* C0407



瀚慖f any of the DTCs listed are set, diagnose those codes first. Refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic



Trouble Code Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle).



3. Ensure that all differential fluid levels are at the proper levels. Refer to Rear Axle Lubricant Level Inspection (See:



Maintenance/Fluids/Fluid - Differential/Service and Repair/Procedures) and Differential Clutch Oil Inspection (See: Transmission and



Drivetrain/Differential Assembly/Differential Clutch/Service and Repair/Differential Clutch Oil Inspection).



瀚慖f a fluid level is below specifications, inspect the rear differential assembly for leaks and repair as necessary. Refill to the proper level,



clear codes, and road test. Verify that DTC C039F is not set. If the DTC resets, proceed to Circuit System Testing.



Circuit/System Testing



Note: The rear drive clutch solenoid valve is calibrated with and is part of the rear differential clutch control module. Both components must be



replaced as a matched set.



Verify DTC C039F is not set.



If the DTC is set, inspect the rear differential assembly for internal or external mechanical damage and repair as necessary. Clear codes and road



test. Verify that DTC C039F is not set. If the DTC resets, replace the K47 rear differential clutch control module/Q48 rear drive clutch solenoid



valve assembly.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for rear differential clutch control module replacement,



setup, and programming



C0040



DTC C0035, C0040, C0045, or C0050



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

No comments:

Post a Comment