2010 Cadillac Truck SRX FWD V6-3.0L Page 1954

2010 Cadillac Truck SRX FWD V6-3.0L Page 1954

瀚慖f greater than the specified range, test the appropriate low reference circuit for a short to voltage, or an open/high resistance. If the circuit

tests normal, replace the K20 ECM.

3. Ignition ON, test for 4.8-5.2 V between both 5-volt reference circuit terminals listed below and ground.

* 5 volt reference circuit terminal 1

* 5 volt reference circuit terminal 2

瀚慖f less than the specified range, test the appropriate 5-volt reference circuit for a short to ground or open/high resistance. If the circuit tests

normal, replace the K20 ECM.

瀚慖f greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the K20 ECM.

4. Verify the appropriate APP sensor voltage parameter is at 0 V.

瀚慖f greater than the specified range, test the appropriate signal circuit terminal listed below for a short to voltage. If the circuit tests normal,

replace the K20 ECM.

* APP sensor 1 signal circuit terminal 3

* APP sensor 2 signal circuit terminal 6

5. Install a 3 A fused jumper wire between the appropriate signal circuit listed below and the 5-volt reference circuit terminal 1. Verify the

appropriate APP sensor voltage parameter is greater than 4.8 V.

* APP sensor 1 signal circuit terminal 3

* APP sensor 2 signal circuit terminal 6

瀚慖f less than the specified range, test the appropriate signal circuit for a short to ground or an open/high resistance. If the circuit tests

normal, replace the K20 ECM.

6. If all circuits test normal, replace the B107 accelerator pedal assembly.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Accelerator Pedal with Position Sensor Assembly Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Accelerator

Pedal/Service and Repair/Accelerator Pedal with Position Sensor Assembly Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming

P2123

DTC P2122, P2123, P2127, P2128, or P2138 (LF1)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P2122

- Accelerator Pedal Position (APP) Sensor 1 Circuit Low Voltage

DTC P2123

- Accelerator Pedal Position (APP) Sensor 1 Circuit High Voltage

DTC P2127

- Accelerator Pedal Position (APP) Sensor 2 Circuit Low Voltage

DTC P2128

- Accelerator Pedal Position (APP) Sensor 2 Circuit High Voltage

DTC P2138

- Accelerator Pedal Position (APP) Sensor 1-2 Correlation