- The quiescent current is too high.Test quiescent current.
NO
Figure legend 1:N71 (Headlamp range adjustment control module)Figure legend 2:N10/1 (Front SAM control unit with fuse and relay module)Test
prerequisite
- The relevant actual value is not okay.
- Battery voltage is OK.
- Fuse N10/1f51 (Fuse 51) is OK.
Test sequence
- Switch off ignition.
- Disconnect connector at component N71 (Headlamp range adjustment control module).
- Measure direct voltage with multimeter between sockets (N71) 20 and (N71) 19
- Switch on ignition.
Specified value:Voltage = [11.0...14.5] VQuestion
- Is the measurement value OK?
YES
The measurement value is OK.Figure legend 1:N71 (Headlamp range adjustment control module)Figure legend 2:N10/1 (Front SAM control unit
with fuse and relay module)Possible cause or remedy in case of malfunction
- Inspect plug connections N71x1 and (N10/1) 24 for damage, loose contact and corrosion, and repair if necessary.
- N71 (Headlamp range adjustment control module)
No comments:
Post a Comment