1.3. Perform mechanical inspection of component Y58/1 (Purge control valve).
Figure legend
- 019Vacuum tester
- Y58/1 (Purge control valve)
Test prerequisite
- Actuation is OK.
Test sequence
- Switch off ignition.
- Connect the vacuum tester to the input of component Y58/1 (Purge control valve) with the 3 x distributor.
- Operate engine at idling speed.
- Engine at operating temperature
- Actuate component Y58/1 (Purge control valve), then with key F2.
Warning!Communication with ECU required.
1081
Purge control system has slight leak / Leak in hose connection or shutoff valve of activated charcoal canister (P0442)
Possible cause:
- Purge control system has leak (function chain)
Affected functions:
- Fuel system
-------------------------------------------------
1085
Major leak in purge system / Hose in system not connected or filler cap open (P0455)
No comments:
Post a Comment