Wednesday, October 27, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 803

2010 Cadillac Truck SRX FWD V6-3.0L Page 803



DTC Descriptor



DTC C0280 54



- Stability System Active Too Long High Temperature



Circuit/System Description



The solenoid valves are integral parts of the brake pressure modulator valve assembly. The brake pressure modulator valve assembly contains an



isolation solenoid valve and a dump solenoid valve for each wheel and a traction control/stability control supply solenoid valve and isolation



solenoid valve for each brake circuit. The solenoid valves are not engaged during normal system operation. When the ABS, traction control or



stability control operation is required the electronic brake control module (EBCM) turns the required solenoid valves ON.



Conditions for Running the DTC



Ignition ON



Conditions for Setting the DTC



Stability control is active for more than 15 s.



Action Taken When the DTC Sets



* The EBCM disables the stability control for the duration of the ignition cycle.



* The traction control/stability control-active indicator turns ON.



Conditions for Clearing the DTC



The condition for setting the DTC is no longer present.



Diagnostic Aids



DTC can set because of extended operation of ABS, traction control or stability control.



Reference Information



Schematic Reference



Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Testing



1. Ignition ON, verify that DTC C0186, C0196, C019B, or C0710 is not set as a present DTC.



瀚慖f any listed DTC is present, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code



Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle) to diagnose that DTC prior to this diagnostic.



2. Ignition OFF, inspect the B99 Steering Wheel Angle Sensor and B119 Multi-axis Acceleration Sensor for correct installation.



瀚慖f loose or incorrect installation is diagnosed, correct the installation of the component.

No comments:

Post a Comment