2010 Cadillac Truck SRX FWD V6-3.0L Page 576
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B2580 02
- High Beam Control Circuit Short to Ground
Diagnostic Fault Information
Circuit/System Description
The headlamp high beam relay is supplied with battery voltage at all times. The turn signal/multifunction switch signal circuit is grounded by
pressing the turn signal/multifunction switch. The body control module (BCM) energizes the headlamp high beam relay by applying ground to the
headlamp high beam relay control circuit. When the headlamp high beam relay is energized, the relay switch contacts close and battery voltage is
applied through the high beam lamp fuses to the high beam lamp supply voltage circuit which illuminates the high beam lamps.
Conditions for Running the DTC
High beam lamps ON.
Conditions for Setting the DTC
The BCM detects a short to ground in the headlamp high beam relay control circuit.
Action Taken When the DTC Sets
The high beam headlamps will always be illuminated.
Conditions for Clearing the DTC
* The DTC will be current for as long as the fault is present.
* When the fault is no longer present, the DTC will be a history DTC.
* A history DTC will clear after 50 ignition cycles.
Reference Information
Schematic Reference
Headlights/Daytime Running Lights (DRL) Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System
Diagram/Headlights/Daytime Running Lights (DRL) Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
No comments:
Post a Comment