2010 Cadillac Truck SRX FWD V6-3.0L Page 620

2010 Cadillac Truck SRX FWD V6-3.0L Page 620

Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information

Circuit/System Verification

Verify none of the following DTCs are set:

* DTC B3109

* DTC B3110

* DTC B3111

* DTC B3112

* DTC B3113

If any of the DTCs are set, replace the battery in the appropriate keyless entry transmitter. Operate the transmitter 3 consecutive times. If the DTC

resets, replace the keyless entry transmitter.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Replacing Keys (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Service and Repair/Replacing Keys)

B3113

DTC B3109-B3113

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions)provides an overview of each diagnostic category.

DTC Descriptors

DTC B3109 00

- Keyless Entry Transmitter 1 Battery

DTC B3110 00

- Keyless Entry Transmitter 2 Battery

DTC B3111 00

- Keyless Entry Transmitter 3 Battery

DTC B3112 00

- Keyless Entry Transmitter 4 Battery

DTC B3113 00

- Keyless Entry Transmitter 5 Battery

Circuit/System Description

With each press of a keyless entry transmitter button, a message containing the current battery state of the transmitter is sent to the remote control

door lock receiver, along with the commanded keyless entry function. The remote control door lock receiver sends this to the body control module

(BCM) to perform the requested function.

Conditions for Running the DTC

A keyless transmitter button is pressed.

Conditions for Setting the DTC

3 consecutive low battery signals are received from the same transmitter.

Action Taken When the DTC Sets

The keyless entry system is inoperative.