Saturday, September 18, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 1563

2010 Cadillac Truck SRX AWD V6-3.0L Page 1563



2. Connect the DT-47825-20 to the 20-way transmission harness connector.



3. Test for less than 10 ohms between the ground circuit terminals listed below and ground.



* Terminal 1



* Terminal 18



瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.



4. Ignition ON, verify that a test lamp illuminates between the ignition and B+ circuit terminals listed below and ground.



* Terminal 10



* Terminal 13



* Terminal 15



瀚慖f the test lamp does not illuminate, test the affected ignition or B+ circuit for a short to ground or an open/high resistance.



5. If all circuits test normal, replace the control solenoid valve assembly.



Repair Instructions



Important:



* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and



Inspection/Programming and Relearning) following all transmission related repairs.



* Before replacing the TCM, perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See:



Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General



Diagnostics/6T70/6T75 - Automatic Transmission/Control Solenoid Valve and Transmission Control Module Assembly Inspection).



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid valve assembly replacement, setup,



and programming



Engine Electrical



DTC P0563



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC P0563



- System Voltage High



Diagnostic Fault Information



Circuit/System Description



The following control modules monitor the system voltage to ensure that the voltage stays within the proper range:



* Engine control module



* Fuel pump control module



* Transmission control module



Damage to components, and incorrect data may occur when the voltage is out of range.



Conditions for Running the DTC

No comments:

Post a Comment