Thursday, September 9, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 1941

2010 Cadillac Truck SRX AWD V6-3.0L Page 1941



P2100



The ECM detects the output circuit for the TAC motor is open, shorted to ground, or shorted to a voltage. The condition exists fro greater than 1 s.



P2101



The ECM detects a 4-50 percent difference between the commanded and the actual throttle plate position, dependant upon the rate of commanded



throttle movement. The condition exists for 1 s.



P2102



The ECM detects an overheat condition with the output driver. The condition exists for 1 s.



P2103



The ECM detects an over load condition with the output driver. The condition exists for 1 s.



P2119



The ECM determines that the throttle valve did not return to the rest position within 1 s. The condition exists for greater than 1 s, or a cumulative of



10 s.



Action Taken When the DTC Sets



DTCs P0638, P2100, P2101, P2102, P2103, and P2119 are Type A DTCs.



Conditions for Clearing the DTC



DTCs P0638, P2100, P2101, P2102, P2103, and P2119 are Type A DTCs.



Diagnostic Aids



Inspect for a condition in which the throttle valve may have been held open. For example, ice may have formed in the throttle bore causing the



throttle valve not to close.



Reference Information



Schematic Reference



Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics



(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Throttle Actuator Control (TAC) System Description (See: Powertrain Management/Computers and Control Systems/Description and



Operation/Throttle Actuator Control (TAC) System Description)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Special Tools



* EL 34730-405 - Injector Test Lamp



* For equivalent regional tools, refer to Special Tools (See: Powertrain Management/Computers and Control Systems/Tools and Equipment).

No comments:

Post a Comment