- Signal wire
- B2/5 (Hot film mass air flow sensor)
End of test
NO
The measurement value is not OK.Possible cause and remedy
- N10/1f43 (Fuse 43)
- Cable for voltage supply
End of test
1347
B2/5 (Hot film mass air flow sensor) : Open circuit / Short circuit to ground or to positive (P0102)
Test 1: Check component B2/5 (Hot film mass air flow sensor).
Test 2: Possible cause:
- B2/5 (Hot film mass air flow sensor)
Affected functions:
- Engine diagnosis
- Engine output
1. Check component B2/5 (Hot film mass air flow sensor).
Test 1.1: Check signal of component B2/5 (Hot film mass air flow sensor) via actual value with engine OFF.
Test 1.2: Check signal of component B2/5 (Hot film mass air flow sensor) via actual value with engine speed greater than 3500 rpm.
Test 1.3: Check reference signal of component B2/5 (Hot film mass air flow sensor).
Test 1.4: Check power supply of component B2/5 (Hot film mass air flow sensor).
1.1. Check signal of component B2/5 (Hot film mass air flow sensor) via actual value with engine OFF.
Warning!Communication with ECU required.
1.2. Check signal of component B2/5 (Hot film mass air flow sensor) via actual value with engine speed greater than 3500 rpm.
Warning!Communication with ECU required.
1.3. Check reference signal of component B2/5 (Hot film mass air flow sensor).
Test sequence
- Switch on ignition.
Status of relevant actual value:
- HFM-SFI ( Reference signal ):Warning! Communication with ECU required.
Specified value
- Reference signal[46...59] ms
Question
- Is the measurement value OK?
YES
The actual value is okay.End of test
NO
The actual value is not o.k.Possible cause and remedy
- Check lines from component N3/10 (ME-SFI [ME] control unit) to component B2/5 (Hot film mass air flow sensor).
- B2/5 (Hot film mass air flow sensor)
1.4. Check power supply of component B2/5 (Hot film mass air flow sensor).
No comments:
Post a Comment