Thursday, August 5, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 524

2010 Cadillac Truck SRX FWD V6-3.0L Page 524



* Control Module References (See: Testing and Inspection/Programming and Relearning) for rear seat heating control module replacement,



setup and programming



B2355



DTC B1825, B2355, B2365, or B2375



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B1825 01



- Driver Seat Recline Position Sensor Circuit Short to Battery



DTC B1825 06



- Driver Seat Recline Position Sensor Circuit Low Voltage/Open



DTC B2355 01



- Driver Seat Front Vertical Position Sensor Circuit Short to Battery



DTC B2355 06



- Driver Seat Front Vertical Position Sensor Circuit Low Voltage/Open



DTC B2365 01



- Driver Seat Rear Vertical Position Sensor Circuit Short to Battery



DTC B2365 06



- Driver Seat Rear Vertical Position Sensor Circuit Low Voltage/Open



DTC B2375 01



- Driver Seat Assembly Horizontal Position Sensor Circuit Short to Battery



DTC B2375 06



- Driver Seat Assembly Horizontal Position Sensor Circuit Low Voltage/Open



Diagnostic Fault Information



Circuit Description



The seat memory control module monitors the position of the seat motors by using hall effect position sensors which are an internal part of each



motor. The module supplies each sensor with a 12 V reference circuit and a low side signal circuit. During seat motor operation, the hall effect



position sensor provides a determined number of pulse signals for every revolution of the motor shaft. The scan tool displays these pulse signals as



counts that range from 0 - 65,535. The module counts the feedback pulses from each sensor to determine seat position and end of travel limits for



each of the seat motors. High scan tool count values indicate forward or upward seat positions while low count values indicate rearward or



downward seat positions.



Conditions for Running the DTC



* DTC B1325 must not be present.

No comments:

Post a Comment