2010 Cadillac Truck SRX FWD V6-3.0L Page 371
B369D 39
The sunshade module has detected and reported via the LIN-Bus that the sunshade actuator has an internal malfunction.
B369D 42
The sunshade module has detected and reported via the LIN-Bus that the sunshade actuator calibration is not programmed.
B369D 4B
The sunshade module has detected and reported via the LIN-Bus that the sunshade actuator calibration is not learned.
Action Taken When the DTC Sets
DTC B369D is stored in the BCM memory.
Conditions for Clearing the DTC
The BCM no longer detects a malfunction in the sunshade actuator circuit.
Reference Information
Schematic Reference
Sunroof Schematics (See: Body and Frame/Roof and Associated Components/Sunroof / Moonroof/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Sunroof Description and Operation (See: Body and Frame/Roof and Associated Components/Sunroof / Moonroof/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
1. Verify that DTC B369D 42 or DTC B369D 4B is not set.
瀚慖f the DTC is set, program or calibrate the K62 Sunroof Sunshade Motor Module. If the DTC resets, replace the K62 Sunroof Sunshade
Motor Module.
2. Replace the K62 Sunroof Sunshade Motor Module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Sunroof Sunshade Motor Replacement (See: Body and Frame/Roof and Associated Components/Sunroof / Moonroof/Sun Shade/Service
and Repair/Sunroof Sunshade Motor Replacement)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for sunshade motor/actuator replacement, setup and
programming
B0408
DTC B0223, B022A, B0233, B023A, B0408, B0418, B0428, or B3531
Diagnostic Instructions
No comments:
Post a Comment