2010 Cadillac Truck SRX FWD V6-3.0L Page 526

2010 Cadillac Truck SRX FWD V6-3.0L Page 526

4. If all circuits test normal, replace the seat motor.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Driver or Passenger Seat Cushion Frame Replacement (See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Driver or

Passenger Seat Cushion Frame Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for seat memory control module replacement, setup,

and programming

B2365

DTC B1825, B2355, B2365, or B2375

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B1825 01

- Driver Seat Recline Position Sensor Circuit Short to Battery

DTC B1825 06

- Driver Seat Recline Position Sensor Circuit Low Voltage/Open

DTC B2355 01

- Driver Seat Front Vertical Position Sensor Circuit Short to Battery

DTC B2355 06

- Driver Seat Front Vertical Position Sensor Circuit Low Voltage/Open

DTC B2365 01

- Driver Seat Rear Vertical Position Sensor Circuit Short to Battery

DTC B2365 06

- Driver Seat Rear Vertical Position Sensor Circuit Low Voltage/Open

DTC B2375 01

- Driver Seat Assembly Horizontal Position Sensor Circuit Short to Battery

DTC B2375 06

- Driver Seat Assembly Horizontal Position Sensor Circuit Low Voltage/Open

Diagnostic Fault Information

Circuit Description

The seat memory control module monitors the position of the seat motors by using hall effect position sensors which are an internal part of each