Friday, August 13, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 709

2010 Cadillac Truck SRX FWD V6-3.0L Page 709



5. If all circuits test normal, test or replace the KR12C windshield wiper speed control relay.



Component Testing



Relay Test



1. Ignition OFF, disconnect the appropriate relay.



2. Test for 60-200 ohm between terminals 85 and 86.



瀚慖f the resistance is not within the specified range, replace the relay.



3. Test for infinite resistance between the following terminals:



* 30 and 86



* 30 and 87



* 30 and 85



* 85 and 87



瀚慖f not the specified value, replace the relay.



4. Test for less than 5 ohm between terminals 30 and 87A.



瀚慖f greater than the specified value, replace the relay.



5. Install a 10 A fused jumper wire between relay terminal 85 and 12 V. Install a jumper wire between relay terminal 86 and ground. Test for



less than 5 ohm between terminals 30 and 87.



瀚慖f greater than the specified range, replace the relay.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Relay Replacement (Attached to Wire Harness) (See: Power and Ground Distribution/Power Distribution Relay/Service and Repair/Relay



Replacement (Attached to Wire Harness))Relay Replacement (Within an Electrical Center) (See: Power and Ground Distribution/Power



Distribution Relay/Service and Repair/Relay Replacement (Within an Electrical Center))



* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, programming and setup



B3881



DTC B3881 or B3882



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B3881 02



- Tail Lamp Circuit Short to Ground



DTC B3881 04



- Tail Lamp Circuit Open



DTC B3882 02



- Right Tail Lamp Circuit Short to Ground



DTC B3882 04



- Right Tail Lamp Circuit Open



Diagnostic Fault Information

No comments:

Post a Comment