2010 Cadillac Truck SRX AWD V6-3.0L Page 1667

2010 Cadillac Truck SRX AWD V6-3.0L Page 1667

P0711

The difference between the transmission fluid temperature (TFT) and TCM temperature and the difference between the TFT and TCM power up

temperature are both greater than 20-50掳C (36-90掳F). The temperature threshold is dependent on the average temperature of the TFT, TCM

temperature, and TCM power up temperature.

P0712

The TFT is less than -74掳C (-101掳F) for 1 minute.

P0713

The TFT is 174掳C (345掳F) or greater for 1 minute.

Action Taken When the DTC Sets

* DTCs P0711, P0712, and P0713 are Type B DTCs.

* The TCM defaults the TFT to the TCM Temperature.

Conditions for Clearing the DTC

DTCs P0711, P0712, and P0713 are Type B DTCs.

Diagnostic Aids

The transmission control module (TCM) temperature sensor is located inside of the control solenoid valve assembly and its output should resemble

that of the transmission fluid temperature (TFT) sensor's output.

Reference Information

Connector End View Reference

* Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

* Inline Harness Connector End Views (See: Diagrams/Connector Views/Multiple Junction Connector/Connector End Views By Number)

Description and Operation

Electronic Component Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and Operation/6T70/6T75 -

Automatic Transmission/Electronic Component Description) for control solenoid valve assembly

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

1. Engine idling at operating temperature, verify the scan tool Trans Fluid Temp. parameter is between -74 and +174掳C (-101 and +345掳F).

瀚慖f not within the specified range, replace the control solenoid valve assembly.

2. Operate the vehicle at 64 km/h (40 mph) for 10 minutes. Monitor the TCM Temperature, TCM Power up Temperature, and the Trans. Fluid

Temp. parameters with a scan tool. The TCM Temperature and the Trans. Fluid Temp. parameters should be within 25掳C (45掳F) of each

other, and the Trans. Fluid Temp. and TCM Power up Temperature parameters should be within 25掳C (45掳F) of each other.

瀚慖f both are greater than the specified range, replace the control solenoid valve assembly.