Tuesday, July 27, 2021

2010 Mercedes Benz C 300 (204.054) V6-3.0L (272.947) Page 1019


YES



The measurement values are OK.End of test



NO



The measurement values are not OK.Possible cause and remedy



- Lines to component B28 (Pressure sensor)



- B28 (Pressure sensor)



Further possible causes of fault



- Vacuum line



End of test



1858



Ratio of HFM signal to intake manifold pressure is too low.



Possible cause:



- B28 (Pressure sensor)



- B2/5 (Hot film mass air flow sensor)



Affected functions:



- Engine output



-------------------------------------------------



Test 1: Check component B2/5 (Hot film mass air flow sensor).



Test 2: Check component B28 (Pressure sensor).



1. Check component B2/5 (Hot film mass air flow sensor).



Test 1.1: Check signal of component B2/5 (Hot film mass air flow sensor) via actual value with engine OFF.



Test 1.2: Check signal of component B2/5 (Hot film mass air flow sensor) via actual value with engine speed greater than 3500 rpm.



Test 1.3: Check reference signal of component B2/5 (Hot film mass air flow sensor).



Test 1.4: Check power supply of component B2/5 (Hot film mass air flow sensor).



1.1. Check signal of component B2/5 (Hot film mass air flow sensor) via actual value with engine OFF.



Warning!Communication with ECU required.

No comments:

Post a Comment