Monday, July 19, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 702

2010 Cadillac Truck SRX FWD V6-3.0L Page 702



Circuit/System Verification



Ignition ON, observe the scan tool Exterior Driver Door Handle Switch parameter while pulling and releasing the B27A door handle switch - driver



exterior. The parameter should change between Active and Inactive.



Circuit/System Testing



1. Ignition OFF, disconnect the harness connector at the B27A door handle switch - driver exterior.



2. Ignition ON, verify the scan tool Exterior Driver Door Handle Switch parameter is Inactive.



瀚慖f not the specified value, test the signal circuit terminal 2 for a short to ground. If the circuit tests normal, replace the K84 keyless entry



control module.



3. Connect the a 3 A jumper harness between the signal circuit terminal 2 and ground. Verify the scan tool Exterior Driver Door Handle Switch



parameter is Active.



瀚慖f not the specified value, test the signal circuit terminal 2 for a open/high resistance. If the circuit tests normal, replace the K84 keyless



entry control module.



4. If all circuits test normal, test or replace the B27A door handle switch - driver exterior.



Component Testing



Static Test



1. Ignition OFF, disconnect the harness connector at the B27A door handle switch - driver exterior.



2. With the switch in the open position, test for infinite resistance between the signal terminal 2 and the ground terminal 1.



瀚慖f not the specified value, replace the B27A door handle switch - driver exterior.



3. With the switch in the closed position, test for less than 5 ohm between the signal terminal 2 and the ground terminal 1



瀚慖f greater than the specified range, replace the B27A door handle switch - driver exterior.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Front Side Door Outside Handle Replacement (See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Handle/Front



Door Exterior Handle/Service and Repair)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for keyless entry control module replacement,



setup, and programming



B3867



DTC B2585 or B3867



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B2585 02



- Park Lamps Control Circuit Short to Ground



DTC B3867 02



- Right Park Lamp Control Circuit Short to Ground



Diagnostic Fault Information

No comments:

Post a Comment