2010 Cadillac Truck SRX AWD V6-3.0L Page 1998

2010 Cadillac Truck SRX AWD V6-3.0L Page 1998

Conditions for Setting the DTC

P1516

The ECM detect an inability to maintain a steady state throttle position for 4 s.

P2101

The ECM detects the difference between the actual throttle position, and the desired position is greater than 7 percent.

P2119

* The ECM detects that the throttle blade did not return to the default position, during power down, within a calibrated amount of time.

or

* The ECM detects the throttle control is driving the throttle in the incorrect direction or exceeds the reduced power limit.

P2176

The ECM detects that both throttle position sensors were greater than 0.95 V during the minimum learn procedure.

Action Taken When the DTC Sets

* DTCs P1516, P2101, and P2176 are type A DTCs.

* DTC P2119 is a type C DTC.

Conditions for Clearing the MIL/DTC

* DTCs P1516, P2101, and P2176 are type A DTCs.

* DTC P2119 is a type C DTC.

Diagnostic Aids

* Inspect for a condition in which the throttle valve may have been held open. For example, ice may have formed in the throttle bore causing

the throttle valve not to close.

* A high resistance condition on the throttle position and throttle actuator control circuits could cause a DTC to set.

* A low battery condition may cause a DTC to set.

Reference Information

Schematic Reference

Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics

(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Throttle Actuator Control (TAC) System Description (See: Powertrain Management/Computers and Control Systems/Description and

Operation/Throttle Actuator Control (TAC) System Description)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification