Sunday, June 13, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 585

2010 Cadillac Truck SRX FWD V6-3.0L Page 585



Interior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Interior Lighting Systems)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning)



Circuit/System Verification



Command the Courtesy Lamps ON and OFF with a scan tool. The courtesy lamps should turn ON and OFF when changing between commanded



states.



Circuit/System Testing



1. Disconnect the harness connector at the appropriate courtesy lamp.



2. Ignition OFF, scan tool OFF, doors CLOSED, interior lamps OFF, test for less than 5.0 ohm between the ground circuit terminal listed below



and ground:



* Instrument Panel Courtesy Lamp - terminal 2



* Door Courtesy Lamp - terminal 2



* Overhead Console Courtesy/Reading Lamp - terminal 2



* Rear Courtesy/Reading Lamp - terminal B



瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.



3. Connect a test lamp between the control circuit terminal listed below and ground:



* Instrument Panel Courtesy Lamp - terminal 1



* Door Courtesy Lamp - terminal 1



* Overhead Console Courtesy/Reading Lamp - terminal 3



* Rear Courtesy/Reading Lamp - terminal C



4. Command the Courtesy Lamps ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the



commanded states.



瀚慖f the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace



the K9 BCM.



瀚慖f the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 BCM.



5. If all circuits test normal, replace the courtesy lamp.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic repair.



* Refer to the appropriate replacement procedure for the lighting component that requires replacement.



* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, programming and setup



B2625



DTC B2625



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

No comments:

Post a Comment