Monday, June 14, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 425

2010 Cadillac Truck SRX FWD V6-3.0L Page 425



* The SDM requests the instrument cluster to illuminate the AIR BAG indicator.



* The SDM disables all deployments.



Conditions for Clearing the DTC



The last 4-digit Primary Data Key in the SDM matches the last 4 digits stored in the BCM.



Diagnostic Aids



This DTC is an indication that an incorrect SDM is installed in the vehicle, or that the SDM and/or the BCM was replaced without reprogramming



the BCM with the new information.



Reference Information



Schematic Reference



SIR Schematics (See: Diagrams/Electrical Diagrams/Air Bag Systems)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



SIR System Description and Operation (See: Restraints and Safety Systems/Air Bag Systems/Description and Operation/SIR System)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



Note: Cycle the ignition after performing the Setup SDM Primary Key procedure in the BCM. This enables the BCM to read the new SDM



primary Key value.



Verify the scan tool SDM Primary Key Status is Valid in the BCM.



If the SDM Primary Key Status is Invalid, perform the Setup SDM Primary Key procedure in the BCM.



B1015



DTC B1015



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC B1015 00



- Vehicle Identification Number Information Malfunction



Circuit/System Description



When the ignition is turned ON, the parking assist control module receives the vehicle identification number (VIN) from the body control module.



The parking assist control module will compare the VIN received to the VIN stored in memory.

No comments:

Post a Comment