Sunday, June 13, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 714

2010 Cadillac Truck SRX FWD V6-3.0L Page 714



The license plate lamps will be inoperative.



Conditions for Clearing the DTC



* The DTC will be current for as long as the fault is present.



* When the fault is no longer present, the DTC will be a history DTC.



* A history DTC will clear after 50 ignition cycles.



Reference Information



Schematic Reference



Exterior Lights Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System Diagram/Exterior Lights Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



Ignition ON, command the License Plate Lamps ON and OFF with a scan tool. The license plate lamps should turn ON and OFF when changing



between the commanded states.



Circuit/System Testing



1. Ignition OFF, disconnect the X902 inline harness connector.



2. Test for less than 10 ohm between the ground circuit terminal 15 and ground.



瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.



3. Connect a test lamp between the control circuit terminal 1 and ground.



4. Ignition ON, command the license plate lamps ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between



the selected states.



瀚慖f the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 BCM.



瀚慖f the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace



the K9 BCM.



5. If all circuits test normal, test or replace the E7L license plate lamp-left or E7R license plate lamp-right.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Liftgate Center Applique Replacement ()



* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, programming and setup



B3884



DTC B3884



Diagnostic Instructions

No comments:

Post a Comment