Wednesday, June 16, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 573

2010 Cadillac Truck SRX FWD V6-3.0L Page 573



2. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 1 and ground.



瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.



3. Ignition OFF, connect the X2 harness connector K9 BCM



4. Disconnect the harness connector at the E5A backup lamp listed below:



* X3 harness connector E5E tail lamp-left (Without T79)



* X1 harness connector E5E tail lamp-left (With T79)



* X3 harness connector E5F tail lamp-right (Without T79)



* X1 harness connector E5F tail lamp-right (With T79)



5. Test for less than 30 ohm between the ground circuit terminal listed below and ground.



* E5E tail lamp-left (Without T79) ground terminal 2



* E5E tail lamp-left (With T79) ground terminal C



* E5F tail lamp-right (Without T79) ground terminal 2



* E5F tail lamp-right (With T79) ground terminal C



瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.



6. Connect a test lamp between the control circuit terminal listed below and ground:



* E5E tail lamp-left (Without T79) control terminal 1



* E5E tail lamp-left (With T79) control terminal D



* E5F tail lamp-right (Without T79) control terminal 1



* E5F tail lamp-right (With T79) control terminal D



7. Engine running, command the Backup Lamps ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between



the selected states.



瀚慖f the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 BCM.



瀚慖f the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace



the K9 BCM.



8. If all circuits test normal, test or replace the E5A backup lamp-left and the E5B backup lamp-right.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Backup Lamp Bulb Replacement (See: Lighting and Horns/Backup Lamp/Backup Light Bulb/Service and Repair)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup and programming



B2575



DTC B2575 or B2699



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC B2575 01



- Left Headlamp Control Circuit Short to Battery



DTC B2575 02



- Left Headlamp Control Circuit Short to Ground



DTC B2575 04



- Left Headlamp Control Circuit Open



DTC B2699 01



- Right Headlamp Control Circuit Short to Battery

No comments:

Post a Comment