Thursday, June 17, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 608

2010 Cadillac Truck SRX FWD V6-3.0L Page 608



Instructions)provides an overview of each diagnostic category.



DTC Descriptor



DTC B3055 00



- No Transponder Modulation or No Transponder



Circuit/System Description



When an ignition key is inserted into the ignition lock cylinder and the ignition mode is changed, the transponder embedded in the head of the key



is energized by the exciter coils surrounding the ignition lock cylinder. The energized transponder transmits a signal that contains its unique value,



which is received by the body control module (BCM). The BCM then compares this value to a value stored in memory. If the value is not correct,



the BCM disables engine start.



Conditions for Running the DTC



Ignition is in the Accessory or Run position.



Conditions for Setting the DTC



The BCM is unable to measure the ignition key transponder value.



Action Taken When the DTC Sets



* Vehicle starting will be disabled.



* The security indicator will illuminate. A service message will be displayed in the driver information center.



Conditions for Clearing the DTC



* A current DTC will be cleared when the BCM detects a valid transponder value from the ignition key.



* A history DTC will be cleared after 100 malfunction-free ignition cycles.



Reference Information



Schematic Reference



Immobilizer Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Diagrams/Electrical Diagrams/Immobilizer



Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Immobilizer Description and Operation (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Description and



Operation/Immobilizer)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information



Circuit/System Verification



1. Inspect all available vehicle keys that they are correct vehicle keys.



瀚慖f not a correct vehicle key, replace the key.



2. While viewing the scan tool BCM Key Part Number, turn ON the ignition with each of the available vehicle keys. The parameter should



display a Key Part Number for all available keys.



瀚慖f any key results in the parameter not reading a Key Part Number, replace the appropriate key.

No comments:

Post a Comment