Saturday, May 22, 2021

2010 Mercedes Benz C 300 (204.054) V6-3.0L (272.947) Page 163


Test sequence



- Switch off ignition.



- Connect socket box (126-pin) to component N3/10 (ME-SFI [ME] control unit).



- Measure direct current with multimeter between sockets [F.4] 100 and [F.8] 104 of the 126-pole socket box tester.



- Switch on ignition.



Specified value



- Amperage[13...18] mA



Question



- Is the measurement value OK?



YES



The test was okay.End of test



NO



The measurement value is not OK.Possible cause and remedy



- Check control line to component N118/3 (Left fuel pump control unit) for Short circuit or open circuit.



Further possible remedies



- Read fault memories of the control units N118/3 (Left fuel pump control unit) and N3/10 (ME-SFI [ME] control unit).



3. Signal wire PWM signal Fuel pump



Figure legend



- A -ConnectionTest cable 35-pin socket box



- 001 -Sockets of component N3/10 (ME-SFI [ME] control unit)



- 05 -35-pin socket box



- 050 -126-pin socket box



- 108 -Test cable 266 589 01 63 00



- N3/10 (ME-SFI [ME] control unit)



- II 1-63ConnectionTest cable



- III 64-126ConnectionTest cable



Warning!



-



- Connection A of test cable 108 may NOT be connected to connection B of the 126-pin socket box (050).

No comments:

Post a Comment