2010 Cadillac Truck SRX FWD V6-3.0L Page 718
2. Test for infinite resistance between the control circuit terminal listed below and ground:
* Right trailer park lamp control terminal 16
* Left trailer park lamp control terminal 4
瀚慖f less than the specified value, test the control circuit for a short to ground. If the circuit tests normal, replace the X88 trailer connector.
3. Test for less than 1 ohm between the control circuit terminals listed below:
* Control terminal 16 at the K68 trailer lighting control module and control terminal 5 at the X88 trailer connector.
* Control terminal 4 at the K68 trailer lighting control module and control terminal 7 at the X88 trailer connector.
瀚慖f greater than the specified range, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal,
replace the X88 trailer connector.
4. If all the circuits test normal, replace the K68 trailer lighting control module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for trailer brake control module replacement,
programming and setup
B3886
DTC B3885 or B3886
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B3885 02
- Trailer Left Tail Lamp Circuit Short to Ground
DTC B3885 04
- Trailer Left Tail Lamp Circuit Open
DTC B3886 02
- Trailer Right Tail Lamp Circuit Short to Ground
DTC B3886 04
- Trailer Right Tail Lamp Circuit Open
Diagnostic Fault Information
Circuit/System Description
The trailer brake control module will receive a serial data message from the body control module (BCM) indicating that the vehicle park lamps
have been activated. The trailer brake control module will then apply system voltage to the trailer tail lamps through their respective voltage supply
circuits.
Conditions for Running the DTC
When the parking lamps are turned on.
Conditions for Setting the DTC
No comments:
Post a Comment