Saturday, May 29, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 679

2010 Cadillac Truck SRX FWD V6-3.0L Page 679



pedals soft stop positions must be learned.



Conditions for Running the DTC



The memory seat control module must be powered.



Conditions for Setting the DTC



This DTC will set if the pedals actuator soft stops are not learned.



Action Taken When the DTC Sets



Manual and memory adjustable pedals operation will be disabled.



Conditions for Clearing the DTC



* The current DTC will become a history DTC when the fault is no longer present and the ignition has been cycled.



* The history DTC will clear after 50 consecutive fault-free ignition cycles have occurred.



Reference Information



Schematic Reference



Adjustable Pedal Schematics (See: Accessories and Optional Equipment/Pedal Positioning System/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Adjustable Pedals Description and Operation (See: Accessories and Optional Equipment/Pedal Positioning System/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



1. Ignition ON, verify that no other adjustable pedal DTCs are set.



瀚慖f other adjustable pedal DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code



Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle).



2. Observe the scan tool Adjustable Pedals soft stop Learn Status parameter. The parameter reading should be learned.



瀚慖f not the specified value, perform the scan tool Learn Adjustable Pedals Softstops procedure. Refer to Adjustable Pedal System



Calibration (See: Accessories and Optional Equipment/Pedal Positioning System/Service and Repair/Procedures). If the DTC resets,



replace the K40 memory seat control module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for memory seat control module replacement, setup, and



programming



B3622



DTC B3622



Diagnostic Instructions

No comments:

Post a Comment