Sunday, May 2, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 1555

2010 Cadillac Truck SRX AWD V6-3.0L Page 1555



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Testing



1. Engine running, accessories OFF, measure and record the battery voltage at the C1 battery terminals. The voltage should be between 12.6 and



15.0 V.



瀚慖f not within the specified range, refer to Charging System Test (See: Starting and Charging/Testing and Inspection/Component Tests



and General Diagnostics/Charging System Test).



2. S39 Ignition Switch OFF, disconnect the harness connectors at the K20 ECM.



3. S39 Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 5 Ohms between the



ground circuit terminals listed below and ground.



* Terminal 73 X2 (LF1)



* Terminal 73 X3 (LF1)



* Terminal 1 X2 (LAU)



* Terminal 2 X2 (LAU)



* Terminal 4 X2 (LAU)



瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.



4. Verify that a test lamp illuminates between the B+ circuit terminals listed below and ground.



* Terminal 52 X1 (LF1)



* Terminal 56 X2 (LAU)



瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.



5. If all circuits test normal, replace the K20 ECM.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming



6T70/6T75 - Automatic Transmission



DTC P0562, P0563, or P2534



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0562



- System Voltage Low



DTC P0563



- System Voltage High



DTC P2534



- Ignition 1 Switch Circuit Low Voltage



Diagnostic Fault Information

No comments:

Post a Comment