Thursday, May 6, 2021

2010 Cadillac CTS Sedan AWD V6-3.6L Page 337

2010 Cadillac CTS Sedan AWD V6-3.6L Page 337



The Display Module, Display Module Actuator, Antenna module, and Audio Amplifier (UQA) may become inoperative.



Conditions for Clearing the DTC



* The condition for setting the DTC no longer exists.



* A history DTC clears after 50 malfunction-free ignition cycles.



Diagnostic Aids



* This DTC may be stored as a history DTC without affecting the operation of the navigation radio.



* If stored only as a history DTC and not retrieved as a current DTC, do not replace the navigation radio.



Reference Information



Schematic Reference



Radio/Navigation System Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical Diagrams/Radio/Navigation System



Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views)



Description and Operation



Navigation System Description and Operation (See: Accessories and Optional Equipment/Description and Operation/Navigation System



Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit



Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Testing



Note: The ignition circuit controls multiple modules/components. Each of the modules will need to be disconnected if the ignition circuit test fails



for a short to voltage or short to ground. Disconnect one module/component at a time while testing the ignition circuit for a short to voltage or short



to ground. If the fault is no longer present when disconnecting a module/component replace that module/component. If the fault is still present with



all the module/component disconnected repair the circuit.



1. Ignition OFF, disconnect one of the connectors listed below at an inoperative module/component:



* Antenna Module



* Radio/HVAC Display X1



* Radio/HVAC Display X2



* Audio Amplifier X3 (UQA only)



2. Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal listed below and ground.



* Antenna Module - terminal 1



* Radio/HVAC Display X1 - terminal 4



* Radio/HVAC Display X2 - terminal 3



* Audio Amplifier (UQA only) - terminal 8



瀚慖f the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance. If the circuit tests normal



replace the Radio.



3. If all circuits test normal, replace the module/component that was disconnected in step 1.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the repair.



* Control Module References (See: Testing and Inspection/Programming and Relearning) for radio and amplifier replacement, programming,



and Setup



* Radio Antenna Module Replacement (Sedan) (See: Accessories and Optional Equipment/Antenna/Antenna, Radio/Service and Repair

No comments:

Post a Comment