2010 Cadillac Truck SRX FWD V6-3.0L Page 537

2010 Cadillac Truck SRX FWD V6-3.0L Page 537

Conditions for Setting the DTC

B2425 0D or B2430 0D

By measuring current and voltage output to the seat heating elements every 10 seconds, the rear seat heating control module calculates that the

heating element resistance is above the maximum resistance.

B2425 0B, B2425 0E, B2430 0B, or B2430 0E

By measuring current and voltage output to the seat heating elements every 10 seconds, the rear seat heating control module calculates that the

heating element resistance is below the minimum resistance.

Action Taken When the DTC Sets

The heated seat function for the affected seat will be disabled.

Conditions for Clearing the DTC

* The current DTC clears when the malfunction is no longer present, and the power mode changes to OFF then back to ACC or RUN.

* The history DTC will clear after 40 consecutive fault-free ignition cycles have occurred.

Reference Information

Schematic Reference

Heated/Cooled Seat Schematics (See: Body and Frame/Seats/Seat Temperature Element/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Rear Heated Seats Description and Operation (See: Body and Frame/Seats/Seat Temperature Element/Description and Operation/Rear Heated

Seats)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

B2425 0B, B2425 0D, or B2425 0E

1. Ignition OFF, disconnect the harness connector at the E14E seat back heating element.

Note: Element resistance must be measured twice to ensure that all failure conditions are simulated. First with the seat unoccupied, then with

the seat occupied.

2. Test for 0.5 - 5 Ohms between terminal A and terminal B.

瀚慖f not within the specified range, replace the E14E seat back heating element.

3. Connect the harness connector at the E14E seat back heating element and disconnect the X2 harness connector at the K29R rear seat heating

control module.

Note: Element resistance must be measured twice to ensure that all failure conditions are simulated. First with the seat unoccupied, then with

the seat occupied.

4. Test for 1 - 7 Ohms between control circuit terminal 3 and control circuit terminal 1.

瀚慖f less than the specified range, test for a short between the control circuits. If the circuits test normal, replace the E14F seat cushion