2010 Cadillac Truck SRX FWD V6-3.0L Page 454

2010 Cadillac Truck SRX FWD V6-3.0L Page 454

Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.

* A history DTC will clear once 50 consecutive malfunction-free ignition cycles have occurred.

Reference Information

Schematic Reference

* Instrument Cluster Schematics (See: Diagrams/Electrical Diagrams/Instrument Panel, Gauges and Warning Indicators/System

Diagram/Instrument Cluster Schematics)

* Power Distribution Schematics (See: Diagrams/Electrical Diagrams/Starting and Charging/Power and Ground Distribution/System

Diagram/Power Distribution Schematics)

* Power Moding Schematics (See: Diagrams/Electrical Diagrams/Starting and Charging/Power and Ground Distribution/System

Diagram/Power Moding Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

* Instrument Cluster Description and Operation (See: Instrument Panel, Gauges and Warning Indicators/Description and

Operation/Instrument Cluster)

* Power Mode Description and Operation (See: Power and Ground Distribution/Description and Operation/Power Mode)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Verify that DTC B144B is not set.

If the DTC is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code Descriptions/Diagnostic Trouble Code

(DTC) List - Vehicle).

Circuit/System Testing

1. Ignition OFF, disconnect the KR74 ignition run relay.

2. Test for less than 10 ohm between the ground circuit terminal 86 and ground.

瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.

3. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 30 and ground.

瀚慖f the test lamp does not illuminate, test the B+ circuit for an open/high resistance.

4. Ignition ON, verify that a test lamp illuminates between the Ignition circuit terminal 85 and ground.

瀚慖f the test lamp does not illuminate, test the Ignition circuit for an open/high resistance. If the circuit tests normal replace the K9 BCM.

5. Ignition OFF, reconnect the KR74 ignition run relay.

6. Disconnect the harness connector at the P16 instrument cluster.

7. Ignition ON, verify that a test lamp illuminates between the ignition terminal 19 and ground.

瀚慖f the test lamp does not illuminate and the Ignition fuse is good, test the ignition circuit for an open/high resistance. If the circuit tests

normal, replace the KR74 ignition run relay. If the ignition fuse is open, test the ignition circuit for a short to ground. If the circuit tests

normal, replace the P16 instrument cluster.