Monday, March 15, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 727

2010 Cadillac Truck SRX FWD V6-3.0L Page 727



3. If all the circuits test normal, replace the K9 BCM.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Fuse Block Replacement (See: Maintenance/Fuses and Circuit Breakers/Fuse Block/Service and Repair/Removal and Replacement/Fuse



Block Replacement)



* Control Module References (See: Testing and Inspection/Programming and Relearning)for BCM replacement, programming and setup



B3889



DTC B3889



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B3889 02



- Trailer Brake Lamps Circuit Short to Ground



DTC B3889 04



- Trailer Brake Lamps Circuit Open



Diagnostic Fault Information



Circuit/System Description



The trailer brake control module will receive a serial data message from the BCM indicating that the vehicle brake lamps have been activated. The



trailer brake control module will then apply system voltage to the trailer stop lamps through their respective voltage supply circuits.



Conditions for Running the DTC



When the brake pedal is pressed.



Conditions for Setting the DTC



B3889 02



The trailer brake control module detects a short to ground on the trailer stop lamp control circuit.



B3889 04



The trailer brake control module detects an open/ high resistance on the trailer stop lamp control circuit.



Action Taken When the DTC Sets



The trailer brake lamps will be inoperative.



Conditions for Clearing the DTC



* The DTC will be current for as long as the fault is present.



* When the fault is no longer present, the DTC will be a history DTC.



* A history DTC will clear after 40 ignition cycles.

No comments:

Post a Comment