Sunday, March 21, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 678

2010 Cadillac Truck SRX FWD V6-3.0L Page 678



1. Ignition OFF, disconnect the harness connector at the M16 adjustable pedal assembly.



2. Ignition OFF, test for less than 10 ohm between the low reference circuit terminal 4 and ground.



瀚慖f greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K40



memory seat control module.



3. Ignition ON, test for 4.8-5.2 V between the 5 V reference circuit terminal 6 and ground.



瀚慖f less than the specified range, test the 5 V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal,



replace the K40 memory seat control module.



瀚慖f greater than the specified range, test the 5 V reference circuit for a short to voltage. If the circuit tests normal, replace the K40 memory



seat control module.



4. Ignition ON, verify the scan tool Adjustable Pedals Horizontal Position parameter is less than 0.45 V.



瀚慖f greater than the specified range, test the signal circuit terminal 5 for a short to voltage. If the circuit tests normal, replace the K40



memory seat control module.



5. Install a 3 A fused jumper wire between the signal circuit terminal 5 and the 5 V reference circuit terminal 6. Verify the scan tool Adjustable



Pedals Horizontal Position parameter is greater than 4.75 V.



瀚慖f less than the specified range, test the signal circuit for short to ground or an open/high resistance. If the circuit tests normal, replace the



K40 memory seat control module.



6. If all circuits test normal, test or replace the M16 adjustable pedal assembly.



B3606 61



1. Ignition ON, verify that no other adjustable pedal DTCs are set.



瀚慖f other adjustable pedal DTCs are set, diagnosis those DTCs first.



2. Ignition OFF, disconnect the harness connector at M16 adjustable pedal assembly.



3. Connect a test lamp between the motor control circuit terminal 2 and terminal 3.



4. Ignition ON, verify that a test lamp illuminates while commanding the adjustable pedals to move in both directions with the scan tool.



瀚慖f the test lamp does not illuminate, test the motor control circuits for an open/high resistance. If the circuits test normal replace the K40



memory seat control module.



5. If all circuits test normal, test or replace the M16 adjustable pedal assembly.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Brake Pedal Assembly Replacement (See: Accessories and Optional Equipment/Pedal Positioning System/Service and Repair/Removal and



Replacement/Brake Pedal Assembly Replacement)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for the K40 memory seat control module



replacement, setup, and programming



B3607



DTC B3607



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC B3607 4B



- Adjustable Pedal Motor Circuit Calibration Not Learned



Circuit/System Description



After replacement of adjustable pedal mechanical components or if the memory seat control module is reprogrammed or replaced, the adjustable

No comments:

Post a Comment