2010 Cadillac Truck SRX FWD V6-3.0L Page 584

2010 Cadillac Truck SRX FWD V6-3.0L Page 584

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Daytime Running Lamp Bulb Replacement (TT6,TT7,TT8 Passenger Side Headlamp) (See: Lighting and Horns/Daytime Running

Lamp/Service and Repair/Daytime Running Lamp Bulb Replacement (TT6,TT7,TT8 Passenger Side Headlamp))Daytime Running Lamp

Bulb Replacement (T84, T85 Passenger Side Headlamp) (See: Lighting and Horns/Daytime Running Lamp/Service and Repair/Daytime

Running Lamp Bulb Replacement (T84, T85 Passenger Side Headlamp))Daytime Running Lamp Bulb Replacement (T84, T85 Driver Side

Headlamp) (See: Lighting and Horns/Daytime Running Lamp/Service and Repair/Daytime Running Lamp Bulb Replacement (T84, T85

Driver Side Headlamp))Daytime Running Lamp Bulb Replacement (TT6,TT7,TT8 Driver Side Headlamp) (See: Lighting and

Horns/Daytime Running Lamp/Service and Repair/Daytime Running Lamp Bulb Replacement (TT6,TT7,TT8 Driver Side Headlamp))

* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming

B2615

DTC B2615

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC B2615 02

- Passenger Compartment Dimming 2 Circuit Short to Ground

Diagnostic Fault Information

Circuit/System Description

Battery voltage for the courtesy lamps is supplied at all times to the body control module (BCM). When the BCM receives a signal to command the

courtesy lamps ON, it then applies voltage through the courtesy lamps control circuits to the courtesy lamps.

Conditions for Running the DTC

The BCM attempts to illuminate the courtesy lamps.

Conditions for Setting the DTC

The BCM detects a short to ground on the courtesy lamp control circuit.

Action Taken When the DTC Sets

The BCM will not attempt to activate courtesy lamps.

Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.

* A history DTC will clear once 100 consecutive malfunction ignition cycles have occurred.

Reference Information

Schematic Reference

Interior Lights Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System Diagram/Interior Lights Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation