2010 Cadillac CTS Sedan AWD V6-3.6L Page 1050

2010 Cadillac CTS Sedan AWD V6-3.6L Page 1050

5. Test for 2-3 ohm between the appropriate high voltage supply circuit and high voltage control circuit.

瀚慖f less than the specified range, test for a short between the high voltage supply circuit and high voltage control circuit. If the

circuits/connections test normal, test or replace the appropriate Q17 fuel injector(s).

瀚慖f greater than the specified range, test the high voltage supply circuit and high voltage control circuit for an open/high resistance. If the

circuits/connections test normal, test or replace the appropriate Q17 fuel injector.

Component Testing

Note: The DMM and test leads must be calibrated to 0 ohm in order to prevent misdiagnosis.

1. Remove the intake manifold and disconnect the appropriate Q17 fuel injector.

2. Test for 1.9-2.3 ohm at 20掳C (68掳F) between the high voltage supply circuit terminal 2 and the high voltage control circuit terminal 1 at the

Q17 fuel injector.

瀚慖f not within the specified range, replace the Q17 fuel injector.

3. Measure the resistance between each terminal at the Q17 fuel injector and the Q17 fuel injector housing/case. The DMM should display OL

ohm.

瀚慖f less than the specified value, replace the Q17 fuel injector.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Fuel Injector Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Injector/Service and Repair/Fuel Injector

Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming

P124C

DTC P1248, P1249, P124A, P124B, P124C, or P124D (w/LF1)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P1248

- Cylinder 1 Injector High Control Circuit Shorted to Control Circuit

DTC P1249

- Cylinder 2 Injector High Control Circuit Shorted to Control Circuit

DTC P124A

- Cylinder 3 Injector High Control Circuit Shorted to Control Circuit

DTC P124B

- Cylinder 4 Injector High Control Circuit Shorted to Control Circuit

DTC P124C

- Cylinder 5 Injector High Control Circuit Shorted to Control Circuit

DTC P124D

- Cylinder 6 Injector High Control Circuit Shorted to Control Circuit

Diagnostic Fault Information