2010 Cadillac CTS Sedan AWD V6-3.6L Page 552

2010 Cadillac CTS Sedan AWD V6-3.6L Page 552

Conditions for Running the DTC

* CTD System is armed

* Intrusion sensor is enabled

Conditions for Setting the DTC

The BCM does not receive the power-up acknowledgement from the intrusion sensor

Action Taken When the DTC Sets

The BCM will ignore all inputs from the intrusion sensor for the remainder of the CTD System arming cycle

Conditions for Clearing the DTC

A current DTC will clear when the RIM receives a power-up acknowledgement from the intrusion sensor during the next CTD system arming cycle

Reference Information

Schematic Reference

Theft Deterrent System Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Diagrams/Electrical Diagrams/Theft

Deterrent System Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Content Theft Deterrent (CTD) Description and Operation (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Description

and Operation/Content Theft Deterrent (CTD) Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit

Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)

Scan Tool Reference

Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for Scan Tool Information

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the intrusion sensor.

2. Ignition ON, verify a test lamp illuminates between the B+ circuit terminal A and ground.

瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.

3. Ignition OFF, disconnect the X7 harness connector at the BCM.

4. Ignition ON, test for less than 1 volt between the following signal circuit terminals and ground:

* Terminal 12

* Terminal 15

瀚慖f greater than the specified range, test the signal circuit for a short to ground.

5. Test for infinite resistance between the following signal circuit terminals and ground:

* Terminal 12

* Terminal 15

瀚慖f less than the specified value, test the signal circuit for a short to ground.

6. Test for less than 2 ohms of resistance between the following signal circuit terminals:

* Terminal 12 at the BCM and terminal B at the intrusion sensor

* Terminal 15 at the BCM and terminal C at the intrusion sensor

瀚慖f greater than the specified range, test the signal circuit for an open/high resistance.