2010 Cadillac CTS Sedan AWD V6-3.6L Page 659

2010 Cadillac CTS Sedan AWD V6-3.6L Page 659



Circuit/System Description



The wheel speed sensor receives ignition voltage from the electronic brake control module (EBCM) and provides a DC square wave signal back to



the module. As the wheel spins, the EBCM uses the frequency of the square wave signal to calculate the wheel speed.



Conditions for Running the DTC



C0035 02 and 05-C0050 02 and 05



* Ignition ON.



* Ignition voltage is greater than 10 volts.



C0035 18-C0050 18



* Ignition ON.



* Ignition voltage is greater than 10 volts.



* No other wheel speed circuit DTCs are set.



* The brake pedal is not pressed.



* Two or three other wheel speeds are greater than 0 km/h.



C0035 0F-C0050 0F



* Ignition ON.



* Ignition voltage is greater than 10 volts.



* The brake pedal is not pressed.



* A DTC is not set for the other wheel speed circuit on the same axle.



Conditions for Setting the DTC



C0035 02-C0050 02



* A short to ground, open/high resistance is detected on the wheel speed sensor signal circuit.



* Wheel speed sensor power supply is less than 7.6 volts.



C0035 05-C0050 05



A short to voltage, short to ground or an open/high resistance is detected on the signal circuit.

Comments

Popular posts from this blog

P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.

Dremel 4300-9/64 Versatile Corded Rotary Tool Kit with Flex Shaft and Hard Storage Case, High Power & Performance, Variable Speed- Engraver, Etcher, Sander, and Polisher, Ultimate Gift for the DIYER

The BMW M5 Sedan & M5 Touring with BMW M Performance Parts.