Sunday, November 8, 2020

2010 Cadillac Truck SRX AWD V6-3.0L Page 875

2010 Cadillac Truck SRX AWD V6-3.0L Page 875



DTC Descriptors



DTC C0870 03



- Control Module Voltage Reference Output Circuit Low Voltage



DTC C0870 07



- Control Module Voltage Reference Output Circuit High Voltage



Diagnostic Fault Information



Circuit/System Description



The suspension control module supplies a 5 V reference voltage and a low reference to each body acceleration sensor and vertical suspension



acceleration sensor. The body acceleration sensors and vertical suspension acceleration sensors supply a signal of 0.5-4.5 V to the suspension



control module.



Conditions for Running the DTC



System voltage is between 9-16 V.



Conditions for Setting the DTC



C0870 03



The suspension control module detected a short to ground on the 5 V reference circuit for 1.5 s.



C0870 07



The suspension control module detected a short to voltage on the 5 V reference circuit for 1.5 s.



Action Taken When the DTC Sets



* The electronic suspension control is disabled for the duration of the ignition cycle.



* The driver information center displays the SERVICE SUSPENSION SYSTEM message.



Conditions for Clearing the DTC



* A present DTC will clear on the next consecutive malfunction-free ignition cycle.



* A history DTC will clear after 41 consecutive malfunction-free ignition cycles.



Reference Information



Schematic Reference



Electronic Suspension Control Schematics (See: Steering and Suspension/Suspension/Suspension Control ( Automatic - Electronic



)/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Electronic Suspension Control Description and Operation (See: Steering and Suspension/Suspension/Suspension Control ( Automatic - Electronic



)/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)

No comments:

Post a Comment