2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1784

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1784

4. Install a 3 A fused jumper wire between the signal circuit terminal B and the low reference circuit terminal A. Verify the scan tool ECT

Sensor parameter is greater than 149掳C (300掳F).

瀚慖f colder than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace

the K20 ECM.

5. If all circuits test normal, test or replace the B34 ECT sensor.

Component Testing

Measure and record the resistance of the ECT sensor at various ambient temperatures, then compare those measurements to the Temperature Versus

Resistance (See: Powertrain Management/Computers and Control Systems/Specifications/Temperature Versus Resistance) table.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Engine Coolant Temperature Sensor Replacement (See: Engine, Cooling and Exhaust/Cooling System/Engine - Coolant Temperature

Sensor/Switch/Coolant Temperature Sensor/Switch (For Computer)/Service and Repair)

* Engine Coolant Thermostat Replacement (Gas) (See: Engine, Cooling and Exhaust/Cooling System/Thermostat/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming

P0131

DTC P0131, P0132, P0137, P0138, P0151, P0152, P0157, or P0158

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0131

- HO2S Circuit Low Voltage Bank 1 Sensor 1

DTC P0132

- HO2S Circuit High Voltage Bank 1 Sensor 1

DTC P0137

- HO2S Circuit Low Voltage Bank 1 Sensor 2

DTC P0138

- HO2S Circuit High Voltage Bank 1 Sensor 2

DTC P0151

- HO2S Circuit Low Voltage Bank 2 Sensor 1

DTC P0152

- HO2S Circuit High Voltage Bank 2 Sensor 1

DTC P0157

- HO2S Circuit Low Voltage Bank 2 Sensor 2

DTC P0158

- HO2S Circuit High Voltage Bank 2 Sensor 2

Diagnostic Fault Information