Sunday, November 15, 2020

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2127

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2127

components, and incorrect data may occur when the voltage is out of range.

Conditions for Running the DTC

The engine is running.

Conditions for Setting the DTC

The FPCM detects that the battery voltage is less than 9 V.

Action Taken When the DTC Sets

DTC P0562 is a type C DTC.

Conditions for Clearing the DTC

DTC P0562 is a type C DTC.

Reference Information

Schematic Reference

Engine Controls Schematics (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Charging System Description and Operation (See: Starting and Charging/Charging System/Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

1. Engine running, accessories OFF, measure and record the battery voltage at the battery terminals. The voltage should be between 12.6 and

15.0 V.

瀚慖f not within the specified range, refer to Charging System Test (See: Starting and Charging/Testing and Inspection/Component Tests

and General Diagnostics/Charging System Test).

2. Ignition OFF, disconnect the harness connectors at the FPCM.

3. Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 5 Ohms between the ground

circuit terminal 1 and ground.

瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.

4. Verify that a test lamp illuminates between the B+ circuit terminal 32 and ground.

瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.

5. If all circuits test normal, replace the FPCM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

No comments:

Post a Comment