Sunday, November 15, 2020

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2125

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2125

ECM

DTC P0562 (ECM)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions)provides an overview of each diagnostic category.

DTC Descriptor

DTC P0562

- System Voltage Low - ECM

Diagnostic Fault Information

Circuit/System Description

The engine control module (ECM) monitors the battery positive (B+) voltage to ensure that the voltage stays within the proper range. Damage to

components, and incorrect data may occur when the voltage is out of range. If the ECM detects low battery voltage, then DTC P0562 will set.

Conditions for Running the DTC

The engine is running.

Conditions for Setting the DTC

The ECM detects that the battery voltage is less than 9 volts for 5 seconds.

Action Taken When the DTC Sets

DTC P0562 is a type C DTC.

Conditions for Clearing the DTC

DTC P0562 is a type C DTC.

Diagnostic Aids

A low voltage DTC in multiple modules indicates a concern in the charging system.

Reference Information

Schematic Reference

Engine Controls Schematics (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Charging System Description and Operation (See: Starting and Charging/Charging System/Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

No comments:

Post a Comment