2010 Cadillac Truck SRX AWD V6-3.0L Page 575

2010 Cadillac Truck SRX AWD V6-3.0L Page 575

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, observe the function of the E4G headlamp-left low beam and the E4F headlamp-right low beam while commanding the low beam

lamps ON and OFF with a scan tool. The E4G headlamp-left low beam and the E4F headlamp-right low beam should turn ON and OFF while

changing between the commanded states.

Circuit/System Testing

1. Ignition OFF, disconnect the harness X1 harness connector at the K9 BCM.

2. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal listed below and ground:

* B+ circuit terminal 3

* B+ circuit terminal 4

瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.

3. Ignition OFF, connect the harness X1 harness connector at the K9 BCM.

4. Disconnect the inline harness connector at the appropriate E4 headlamp-low beam listed below:

* E4G headlamp-left low beam X115 inline harness connector

* E4F headlamp-right low beam X116 inline harness connector

5. Connect a test lamp between the control circuit terminal G and ground.

6. Ignition ON, command the low beam lamps ON and OFF with a scan tool. The test lamp should turn ON and OFF while changing between

the commanded states.

瀚慖f the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 BCM.

瀚慖f the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace

the K9 BCM

7. If all circuits test normal, replace the headlamp bulb or the headlamp.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Headlamp Replacement (See: Lighting and Horns/Headlamp/Service and Repair/Removal and Replacement/Headlamp Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming

B2580

DTC B2580

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.