2010 Cadillac Truck SRX AWD V6-3.0L Page 867

2010 Cadillac Truck SRX AWD V6-3.0L Page 867

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions)provides an overview of each diagnostic category.

DTC Descriptor

DTC C0750 03

- Left Front Tire Pressure Sensor Low Voltage

DTC C0750 29

- Left Front Tire Pressure Sensor Too Few Pulses

DTC C0750 39

- Left Front Tire Pressure Sensor Internal Malfunction

DTC C0755 03

- Right Front Tire Pressure Sensor Low Voltage

DTC C0755 29

- Right Front Tire Pressure Sensor Too Few Pulses

DTC C0755 39

- Right Front Tire Pressure Sensor Internal Malfunction

DTC C0760 03

- Left Rear Tire Pressure Sensor Low Voltage

DTC C0760 29

- Left Rear Tire Pressure Sensor Too Few Pulses

DTC C0760 39

- Left Rear Tire Pressure Sensor Internal Malfunction

DTC C0765 03

- Right Rear Tire Pressure Sensor Low Voltage

DTC C0765 29

- Right Rear Tire Pressure Sensor Too Few Pulses

DTC C0765 39

- Right Rear Tire Pressure Sensor Internal Malfunction

Circuit/System Description

The tire pressure monitor (TPM) system has a radio frequency (RF) transmitting pressure sensor in each wheel/tire assembly. As vehicle speed

increases, centrifugal force closes the sensors internal roll switch, which puts the sensor into Rolling mode. The body control module (BCM)

receives and translates the data contained in the tire pressure sensor RF transmissions into sensor presence, sensor mode, and tire pressure. Once

vehicle speed is greater than 40km/h (25 mph), the BCM waits for the first sensor to go into Rolling mode, then checks if all sensors have gone into

Rolling mode. If one or more sensors do not go into these modes, or do not transmit at all, the BCM will set DTC C0750, C0755, C0760, or C0765

respectively.

Conditions for Running the DTC

Vehicle speed is greater than 40 km/h (25 mph).

Conditions for Setting the DTC

* A sensor does not transmit for 18 minutes.

* A sensor low battery condition.

Action Taken When the DTC Sets

* The tire pressure monitor indicator icon on the instrument panel cluster (IPC) flashes for 1 minute and then remains illuminated after the

ignition switch is cycled ON and the IPC bulb check is complete.