2010 Cadillac Truck SRX AWD V6-3.0L Page 1520

2010 Cadillac Truck SRX AWD V6-3.0L Page 1520

瀚慖f greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the K20 Engine Control

Module.

瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace

the K20 Engine Control Module.

4. If all circuits test normal, replace the appropriate fuel level sensor.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Primary Fuel Level Sensor Replacement (See: Powertrain Management/Computers and Control Systems/Fuel Level Sensor/Service and

Repair)

* Secondary Fuel Tank Module Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank Unit/Service and

Repair/Secondary Fuel Tank Module Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for the ECM replacement, programming and setup

P0464

DTC P0461-P0464, P2066, P2067, or P2068

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0461

- Fuel Level Sensor 1 Performance

DTC P0462

- Fuel Level Sensor 1 Circuit Low Voltage

DTC P0463

- Fuel Level Sensor 1 Circuit High Voltage

DTC P0464

- Fuel Level Sensor Circuit Intermittent

DTC P2066

- Fuel Level Sensor 2 Performance

DTC P2067

- Fuel Level Sensor 2 Circuit Low Voltage

DTC P2068

- Fuel Level Sensor 2 Circuit High Voltage

Diagnostic Fault Information

Circuit/System Description

The primary fuel level sensor and the secondary fuel level sensor change resistance based on fuel level. The engine control module (ECM) monitors

the signal circuits of the primary fuel level sensor and the secondary fuel level sensor in order to determine the fuel level. When the fuel tank is full,

the resistances of both fuel level sensors are low and the ECM senses a low signal voltage on both the signal circuits of the primary fuel level

sensor and the secondary fuel level sensor. When the fuel tank is empty, the resistances of the fuel level sensors are high and the ECM senses a high