Monday, July 20, 2020

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1626

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1626



* The TCM enables torque management.



* The TCM freezes transmission adaptive functions.



* The TCM turns OFF all solenoids.



* The TCM turns OFF the TCC solenoid.



P0723



* DTC P0723 is a Type A DTC.



* The high side driver is turned OFF.



* The TCM turns OFF all solenoids.



* The TCM freezes transmission adaptive functions.



* The TCM enables torque management.



Conditions for Clearing the DIC/DTC



DTCs P0722 and P0723 are Type A DTCs.



Diagnostic Aids



Inspect the ISS/OSS, harness, connector and control solenoid valve assembly for metallic debris and output shaft housing machined slots for



damage or misalignment. Proper torque of the ISS/OSS mounting bolt is critical to proper speed sensor operation.



Reference Information



Schematic Reference



Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams)



Connector End View Reference



* Component Connector End Views (See: Diagrams/Connector Views)



* Inline Harness Connector End Views (See: Power and Ground Distribution/Multiple Junction Connector/Diagrams)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit



Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)



Description and Operation



Electronic Component Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and Operation/Electronic



Component Description)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Special Tools



DT-47825-10 - Jumper Harness



For equivalent regional tools, refer to Special Tools (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Tools and Equipment).



Circuit/System Verification



1. Ignition ON, verify with a scan tool the transmission ISS/OSS supply voltage test status parameter displays OK.



2. Operate the vehicle at 16-32 km/h (10-20 mph) while observing the Transmission OSS parameter on the scan tool. The Transmission OSS



parameter should vary with the vehicle speed and not drop out.



3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the



conditions that you observed from the Freeze Frame/Failure Records data.



Circuit/System Testing



Note: You must perform the Circuit/System Verification first.



1. Ignition OFF, remove the control solenoid valve assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly



Replacement (See: Powertrain Management/Transmission Control Systems/Actuators and Solenoids - Transmission and



Drivetrain/Actuators and Solenoids - A/T/Shift Solenoid/Service and Repair).

No comments:

Post a Comment