Wednesday, March 4, 2020

2010 Mercedes Benz C 300 (204.054) V6-3.0L (272.947) Page 244


Test sequence



- Measure direct voltage with multimeter between sockets (M.80) 80 and (M.44) 44 of the 126-pole socket box tester.



- Switch on ignition.



Specified value



- Voltage[4.8...5.3] V



Question



- Is the measurement value OK?



YES



The measurement value is OK.Possible cause and remedy



- Signal wire



- B70 (Crankshaft Hall sensor)



End of test



NO



The measurement value is not OK.Possible cause and remedy



- Lines to component B70 (Crankshaft Hall sensor)



End of test



0119



No tooth space on sensor rotor detected or wiring error (P0336)



Possible cause:



- B70 (Crankshaft Hall sensor)



Affected functions:



- Engine diagnosis



-------------------------------------------------



Test 1: Check component B70 (Crankshaft Hall sensor).



1. Check component B70 (Crankshaft Hall sensor).



Test 1.1: Test signal voltage of component B70 (Crankshaft Hall sensor).



Test 1.2: Check power supply of component B70 (Crankshaft Hall sensor).



1.1. Test signal voltage of component B70 (Crankshaft Hall sensor).



Test 1.1.1: The engine does not start.



Test 1.1.2: Engine running



1.1.1. The engine does not start.



Figure legend



- A -ConnectionTest cable 35-pin socket box



- 001 -Sockets of component N3/10 (ME-SFI [ME] control unit)



- 05 -35-pin socket box



- 050 -126-pin socket box



- 108 -Test cable 266 589 01 63 00



- N3/10 (ME-SFI [ME] control unit)



- II 1-63ConnectionTest cable



- III 64-126ConnectionTest cable



Warning!



- Connection A of test cable 108 may NOT be connected to connection B of the 126-pin socket box (050).



Continue to test with button F2

No comments:

Post a Comment