2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2797
The actual throttle position does not match the predicted throttle position for greater than 0.2 s.
P2119
The ECM detects that the throttle blade did not return to the default position when the TAC motor is not powered-up, during power down for
greater than 0.5 s.
P2176
The ECM detects that both throttle position (TP) sensors were greater than a predetermined voltage during the minimum throttle learn procedure for
greater than 2 s.
Action Taken When the DTC Sets
P1516, P2101, and P2176
* DTCs P1516, P2101, and P2176 are Type A DTCs.
* The control module commands the TAC system to operate in the Reduced Engine Power mode.
* A message center or an indicator displays Reduced Engine Power.
* Under certain conditions, the control module commands the engine OFF.
P2119
* DTC P2119 is a Type C DTC.
* The driver information center, if equipped, may display a message.
Conditions for Clearing the MIL/DTC
* DTCs P1516, P2101, and P2176 are Type A DTCs.
* DTC P2119 is a Type C DTC.
Diagnostic Aids
* If the Throttle Sweep Test is not available on the scan tool, observe the scan tool TAC Motor parameter while performing the following tests:
- Slowly depress the accelerator pedal to WOT and then slowly return the pedal to closed throttle. Repeat the procedure several times.
- Rapidly depress the accelerator pedal from the rest position to the wide open throttle position (WOT) and release pedal. Repeat the
procedure several times.
The TAC Motor parameter should display Enabled. If Disabled is displayed, continue diagnosis in Circuit/System Testing.
* Inspect for a condition in which the throttle valve may have been held open. For example, ice may have formed in the throttle bore causing
the throttle valve not to close.
* A high resistance condition on the throttle position and throttle actuator control circuits could cause a DTC to set.
* A low battery condition may cause a DTC to set.
Reference Information
Schematic Reference
Engine Controls Schematics (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Throttle Actuator Control (TAC) System Description (See: Powertrain Management/Computers and Control Systems/Description and
Operation/Throttle Actuator Control (TAC) System Description)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
No comments:
Post a Comment