2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1484

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1484

driver in the voltage regulator turns the field windings ON and OFF. The ECM uses the PWM signal input to determine the generator load on the

engine. This allows the ECM to adjust the idle speed to compensate for high electrical loads. The ECM monitors the status of the generator field

duty cycle signal circuit. When the ignition is ON and the engine is OFF, the ECM should detect a duty cycle near 0%. When the engine is running,

the duty cycle should be between 5-99%.

Conditions for Running the DTC

P0625

* The engine is running.

* The engine speed is less than 3 000 RPM.

P0626

* The engine is not running.

* The ignition is in the ON position.

Conditions for Setting the DTC

P0625

The ECM detects a pulse width modulated (PWM) signal less than 5% for 15 s.

P0626

The ECM detects a pulse width modulated (PWM) signal greater than 65% for 15 s.

Action Taken When the DTC Sets

DTC P0625 and P0626 are C type DTCs.

Conditions for Clearing the DTC

DTC P0625 and P0626 are C type DTCs.

Reference Information

Schematic Reference

Starting and Charging Schematics (See: Starting and Charging/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Charging System Description and Operation (See: Starting and Charging/Charging System/Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Engine running, observe the scan tool Generator F-Terminal Signal Circuit parameter. The Generator F-Terminal Signal Circuit parameter should

display between 5-99%.

Circuit/System Testing

1. Verify that a test lamp illuminates between the G13 Generator B+ terminal A X1 and ground.